How to install the safety light curtain

Jul 19, 2021 Leave a message

1. View the product manual

 

Whether you are buying anything, especially electronic and electrical products, you need to read the manual carefully. There is no doubt.

 

2. Punch

 

Safe purchase needs to be installed on the mechanical operating table to be fixed. If the position of the hole is not correct, it may affect the normal operation and cause the light curtain to be scratched.

 

3. Wiring

 

The safety light curtain installation manual has a specific installation wiring diagram, which requires the installer to install it strictly according to the manual. At the same time, it is best to confirm the wiring with the salesperson responsible for you after the wiring is completed. Only after the confirmation can it be used normally. Avoid wiring. Man-made damage caused by mistakes.

 

4. Align

 

Fix the position of the light curtain according to the instructions, including the illuminator and the light receiver, to ensure that the grating can align the light normally, and keep the two on a horizontal plane. At the same time, fix the position of the controller. Damage to the controller during operation.

 

5. Detect and test

 

Check whether the bracket of the safety light curtain is loose and fastened as a whole. If there is no abnormality, the installation is successful. After the inspections are normal, a test run is required, and each beam needs to be blocked with foreign objects to check whether each beam is effective. At the same time, avoid direct limb detection during the test, and other foreign objects can be used for detection.